Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
all in all a much cheaper solution than buying a whole new stepper motor. The very first one i grabbed, and replaced, it works fantastic!
Cons
The holes are not concentric and are also not drilled along the vertical axis. The teeth are too shallow and clog then strip the filament that leads to excessive under extrusion.
Highlights
Quality
I can't think of anything negative about the product or transaction.
These are so much better the the brass ones and even the ones that my printer came with!
But it was just the terrible quality of my old ones.
Once off, these gears do not need to be press fit, and can be tightened with the installed grub screws.
Price
It was just what i was looking for a good price.
Competitiveness
So far seems to be much stronger than the stock brass gear.
Tldr: all in all a much cheaper solution than buying a whole new stepper motor.
Overview
- How are reviewers describing this item?
motor, stock, easy, pro and old. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 546 reviews as of our last analysis date on Jan 5 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I replaced this on my ender 3 pro
Posted by a reviewer on Amazon
The extruder wheel mysteriously got very loose on my ender 3 pro
Posted by a reviewer on Amazon
It was so loose that it actually fell off while i was troubleshooting the issue
Posted by a reviewer on Amazon
Turns out that one of the tiny set screws holding it on had backed itself out and was swallowed up by the universe never to be seen again
Posted by a reviewer on Amazon
As i have several printers and these pieces do wear out over time i thought i would give it a try
Posted by a reviewer on Amazon
After a while they will start to slip because the filament wears a smooth groove into the wheel
Posted by a reviewer on Amazon
Just seat the motor vertically in the vice resting the weight of the motor on the stock gear between the jaws of the vice
Posted by a reviewer on Amazon
Then tap on the motor shaft with a screw driver and hammer to gradually slide the shaft out of the gear be prepared to catch the motor safely
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found