What does this mean?
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
pros
See Details
pros
See Details
Faster Extrusion
Customers have a generally positive opinion towards the faster extrusion capability of the product, with some reporting noticeable improvements in print speed and reduced stringing issues. However, a small number of customers experienced clogging issues after a few hours of use.
Highlights
Quality
So far i have successfully printed pla, petg and carbon infused filaments through this nozzle and it has done so flawlessly wit... Read More
I purchased this copper nozzle and it has so far removed all of the filament sticking issues.
No matter what i tweaked i could not get marble pla to print, just kept clogging up my nozzle.
This nozzle extruded it straight down onto my bed consistently with no curling.
Price
For quality, i give it a 8/10 especially for the price point.
Overview
- How are reviewers describing this item?
stock, far and pro. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 104 reviews as of our last analysis date on Mar 6 2025.
Helpful InsightsBETA
Posted by a reviewer on Amazon
As seen in the video i did an 100mm extrude test and the petg came out like butter
Posted by a reviewer on Amazon
Initially i did not see any curl to my filament after removing the extruded portion however after a while it did curl and i assume that is attributed to the heat
Posted by a reviewer on Amazon
Printed a first layer test successfully and i was off to my new print
Posted by a reviewer on Amazon
It is imperative that the nozzle is tightened against the heat break and not the block to get a good seal
Posted by a reviewer on Amazon
Made sure that this was the case while the hotend was at my typical print temp 245 deg and tightened it
Posted by a reviewer on Amazon
All i print is clear petg lately but nothing ever abrasive
Posted by a reviewer on Amazon
I used a magnifier to get an up close look at the nozzle tip which to me is very important
Posted by a reviewer on Amazon
Although there as a little damage around the top its so microscopic that it has no bearing on my print as far as i can see
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
