Posted by a reviewer on Amazon

If you have a large project that you plan to do post processing and sanding anyway go for this even better if you get the 3pack5pack sales

Posted by a reviewer on Amazon

You will need to go to preferences to enable these settings

Posted by a reviewer on Amazon

After the initial layer the following setting were used extruder 202° build plate 50° print speed 60

Posted by a reviewer on Amazon

From 225 202° the finish appeared to be about the same

Posted by a reviewer on Amazon

There are reasons the injection industry has massive dryers right before extrusion

Posted by a reviewer on Amazon

All of my plastic lives in a 60c heated compartment of my printer cabinet and i dont print before 24 hours of drying with any plastic

Posted by a reviewer on Amazon

So i took a chance and bought a spool of the translucent pla while it was on sale figuring that if it turned out bad i could just return it

Posted by a reviewer on Amazon

I have an ender 3 and have been printing hatchbox 200c so i tried a print of this 210c and it seemed to print fine but after closely looking at it the layer adhesion was very poor and the print was extemely brittle