Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
At 36 points the bed leveling procedure takes about 5 minutes. It's 3mm, and if you can't shim the probe to get that, you'll need to figure out what the difference is and set that as your z- offset after every auto bed leveling operation.
Only complaint is that these stay lit when not in us which can screw with my webcam. My only issue is that the cable is not an extention cable but a replacement cable.
Way better than the capacitive/inductive sensors. Just thoughts for consideration. But anyways, the product works great.
The max is 15, but that seemed like overkill. It gives me consistent results on bed leveling and mapping my bed surface.
Cons
This design is old and unreliable and way overpriced! Get a bltouch, just not this model. This negative review is only to warn inexperienced users and/or users with out time to really learn coding that this product can give you a very large headache. ... Read More
Since the entire base of the bltouch is molded from a single piece of plastic, there's no way to simply replace the base. The wiring that comes with the kit is not the same as depicted. It sends an error to marlin and then you have to restart marlin t... Read More
Highlights
Quality
In other words, the bltouch works well with the skr mini e3 v3.
I've been using this little guy's predecessor for years and it improves print quality (and more importantly, adhesion) considerably.
Bigtree tech board refused to work with the bltouch i had, instructions indicated it might not be genuine, so i bought this fro... Read More
With paper, you should feel it drag with a little resistance, similar to how you manage it with the manual bed leveling.
Price
This is a good kit, has most everything you need, and at a good price.
Competitiveness
Easy to install on creality products ender 3 , cr10s5
5 and 4 mm with original creality bltouch bracket.
Now, stop and write down the value.
So, i have an elegoo neptune 2s fdm printer.
Overview
- How are reviewers describing this item?
great. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has detected that Amazon has altered, modified or removed reviews from this listing. We approximate total reviews altered up to 115.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 428 reviews as of our last analysis date on Dec 14 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
It was exibiting odd behavior and preventing the printer from completing the homing process during a print
Posted by a reviewer on Amazon
Took me a few days to realize as it didnt look like an extention cable
Posted by a reviewer on Amazon
If you’re going to install one of these on a cr10s pro v1 you can’t wire this up to the daughter board on the x gantry
Posted by a reviewer on Amazon
Bigtree tech board refused to work with the bltouch i had instructions indicated it might not be genuine so i bought this from the board manufacturer
Posted by a reviewer on Amazon
I just move that one to another printer
Posted by a reviewer on Amazon
I had a cr touch that worked ok
Posted by a reviewer on Amazon
For some reason that probe broke at one of its mounting points
Posted by a reviewer on Amazon
It caused me to chase my tale and ruin several bed plates
Review Count History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found