What does this mean?Highlights
Quality
I haven't used them as yet but they seem like good quality.
Oddly, i can't seem to find any listings that show the dimensions of the total product.
I ordered the wrong size but they were very good quality
Shipping
I don't know how long they will last compared to the original, but the price is right the shipping is reasonable.
Competitiveness
They worked perfectly as upgrades for my monoprice printer.
Made my a8 run much smoother than the stock bearings.
If you try tightening these on a bolt they'll grind.
Overview
- How are reviewers describing this item?
good, quality, fit, last and smooth. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 298 reviews as of our last analysis date on Feb 12 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Seems to be a dropin replacement for original prusa i3 mk2smk3
Posted by a reviewer on Amazon
Some bores were off center and dont rotate around the center correctly
Posted by a reviewer on Amazon
You wouldnt think such a small bearing would make such a horrible noise
Posted by a reviewer on Amazon
They are stupid cheap and youre asking them to do a lot of work
Posted by a reviewer on Amazon
I bought these to replace the existing idlers on my anet a8 and unfortunately these were too wide to fit either in the xbracket where the stock idler was or my printed tensioner
Posted by a reviewer on Amazon
These also seemed to not roll as freely as i would like but you get what you pay for
Posted by a reviewer on Amazon
The bearings work fine taking load from a belt but theres no spacer between the two bearings and theyre too small to take any side loading
Posted by a reviewer on Amazon
If you try tightening these on a bolt theyll grind
Review Count History
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
