What does this mean?Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
The gears aren't worn. It still grips the filament as it should. Retraction retract speed - 5.
The biqu h2 v2s (not the lite version) works as advertised. Needless to say i am impressed with this little extruder. Very nice looking haven mount it.
Highlights
Quality
I highly recommend upgrading to the ti heat break and get thermistor and heater cartridge good for 350 c for max versatility
The machining looks great, the gears run smoothly.
The metal gears move smoothly and i have had zero issues that you might have heard of on the initial versions of this extruder.
The old system was a pain to setup new filament or simply remove/replace as the filament never went back directly in the chambe... Read More
Price
After reviewing i found the biqu to be what i needed and it was on sale.
Finally a water cooled hotend that isn't stupidly expensive.
Packaging/appearance
I haven't installed it yet, but first impressions it looks great.
Competitiveness
Results are much better than the factory bowden extruder or the dual-drive extruder that i had previously upgraded.
If i was doing it again, i'd buy the standard variant, and see if i could get an all metal throat for it instead of going for t... Read More
Overview
- How are reviewers describing this item?
great, better and few. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 121 reviews as of our last analysis date on Mar 14 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
In short this guy by itself didnt let me do that and honestly has a fairly tough time being used with more 34mundane34 components
Posted by a reviewer on Amazon
The reasoning is actually obvious when you actually read over the material which i didnt do a good enough job of the thermistor needs special attention and an extra slot on your control board
Posted by a reviewer on Amazon
This isnt a big deal if you have one of the bigtree third party boards or something similar but if you have a standard control board be aware that youre going to need a one of those to go along with this extruder
Posted by a reviewer on Amazon
In addition the heating blocks slot for that 500c thermistor is not a standard size the one used is a 4mm diameter probe where the 34normal34 thermistors use a 3mm probe
Posted by a reviewer on Amazon
This means that you cant use a standard probe in this guy either youre stuck to either buying an entirely new board or replacing the heat block entirely
Posted by a reviewer on Amazon
I ended up having to use the old heating block screwed onto the bottom of the b2s heat break to get a working machine
Posted by a reviewer on Amazon
Other than that the thing seems to be pretty solidly made and is indeed very small for a direct drive hot endextruder
Posted by a reviewer on Amazon
If i was doing it again id buy the standard variant and see if i could get an all metal throat for it instead of going for the 500c model
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
