What does this mean?Pros & Cons
Pros
As to practicality of the design, i think integratating hotend heatsink into extruder is the most optimal design choice. My only other concern is that i haven't been able to find silicone socks to fit the heat block and the sock that came with it is a... Read More
Cons
The design on this requires special mounting with a lot of fiddling required. I just don't see this as a worthwhile upgrade. This is the first time i’ve gotten a prime item that was so obviously garbage.
Highlights
Quality
The quality and build of this part is impressive.
I know there were some issues with the v1 but they have been addressed and work great.
'extra' mounting holes are on a 'wrong side', side where mounting is impractical because of lever and the thumb-wheel.
Glad i waited for the v2 release of the biqu h2 extruder as they seem to have taken care of the issues with the clicking extruder.
Packaging/appearance
You will e happy with this extruder just make sure that you are able to solder/crimp/extend your wires if your mainboard is far... Read More
Competitiveness
I use ultimaker cura as my slicer.
I ordered a second biqu h2 directly from biqu for my anycubic mega s.
Overview
- How are reviewers describing this item?
great, better and few. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 101 reviews as of our last analysis date on Apr 28 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Namely i printed a better spool holder and a filament guide
Posted by a reviewer on Amazon
I have had 4 particularly annoying spools of pla
Posted by a reviewer on Amazon
About every 3 feet the filament would snap it was oddly brittle in those places
Posted by a reviewer on Amazon
Thats the whole reason for the upgrade
Posted by a reviewer on Amazon
I just got annoyed having to dislodge the piece of filament in the bowden tube and feed it back in again
Posted by a reviewer on Amazon
The h2 weighs only 216g which was important because i wanted to drift as little from the original extruder setup as possible
Posted by a reviewer on Amazon
Direct drive extruders are by nature heavier
Posted by a reviewer on Amazon
Ive seen a lot of reviews about this particular extruder that go all crazy about balance and instability because there are only two screws holding it on the mounting plate
Review Count History
Price History
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
