Highlights
Quality
Great quality petg 3d printing filament with top features of toughness enhanced for ease of printing with high purity and low s... Read More
Good product, works best at 215* on my cr10s will need to tinker with retraction settings to prevent stringing.
Novamaker really shows off their quality petg filaments with this roll able to meet any and all demands for printing functional... Read More
The thread was consistent so it didn't warp in the printing process and the color was even and the quality was strong.
Price
It took a while to dial the settings correctly and i'm still finding a little stringing but the adhesion is pretty good, the co... Read More
Plus, you simply can't beat the price!
I was skeptical because the price was so good, but i have already used up the whole roll and have had no complaints, so i have ... Read More
Reads transparent colors, but this green petg isn't transparent in comparison to others.
Packaging/appearance
So it's not what i expected, i knew petg was softer and more flexible but this is almost like tpu.
I used it mainly to allow light to pass through the part.
Competitiveness
Good performing petg filament in my replicator 2 3d printer.
I print a ton of stuff to sell and this is by far one of my favorite new petg filaments.
Not a uhmw, nylon, ptfe, but not horribledownsides:has that wet look (can takeaway from detail, especially in a photo)is kinda translucent.
I'm printing at 250c with a 85c build plate.
Overview
- How are reviewers describing this item?
great, good and color. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 252 reviews as of our last analysis date on May 27 2021.
Helpful InsightsBETA
Posted by a reviewer on Amazon
The real surprise here was the customer service i counted this roll a loss and didnt think much of it
Posted by a reviewer on Amazon
Below is my original reviewtitle says it all opened a fresh sealed bag and after my 5th calibration cube which i could physically see bubbles pushing though the nozzle at 220c i had to stop and dry the filament for 12 hours
Posted by a reviewer on Amazon
The green in the photo is the nova petg
Posted by a reviewer on Amazon
Could just be the nature of the color
Posted by a reviewer on Amazon
Very little to no stringing when settings are set correctly
Posted by a reviewer on Amazon
Print fast and well look at the dragon
Posted by a reviewer on Amazon
You can just barely see the infill through the top layers of the print depending on your model
Posted by a reviewer on Amazon
Overall this has not been too bad for printing