Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Took maybe 30 minutes to fully install from unboxing to mounting to running cables to installing new firmware. Was upgrading the stock hotend on the sidewinder x1 to the e3d hemera.
Once configured my print quality and first layer adhesion were amazing. Drastically increased the quality of prints. Helps with adhesion is a lot better due to the better leveling.
White or translucent filament color still carries the operating glow. The v2 has a dedicated slot for bl touch so it would be nice to see the correct connector.
Cons
It's almost like the probe would stick to the inside of its container. The second works very inconsistently oftentimes resulting in the same flashing error.
Highlights
Quality
This product works as advertised, with a few caveats.
I followed the instructions from the website and had it running with minimal issues.
I would not recommend this as a first step for someone who has not had a lot of experience dealing with the printer yet.
I do wish i'd gone with the 2m wiring so that i could have ran the wiring with the factory stuff but the 1m is about 6-8 inches shy.
Packaging/appearance
, load cells built into the hotend), but these things are still great.
Was upgrading the stock hotend on the sidewinder x1 to the e3d hemera.
Competitiveness
This honestly saves so much time an hastle.
Added g-code found on youtube installation video and solved my warped bed issue.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Replaced a broken bl touch my fault
Posted by a reviewer on Amazon
The one you will receive is the new version with a connector port in the back
Posted by a reviewer on Amazon
Poor documentation no mounting hardware at all gonna have to splice the wires to make it long enough
Posted by a reviewer on Amazon
If your using a sv01 check your board with a volt ohm meter ground and voltage were swapped
Posted by a reviewer on Amazon
You cant simple plug this in and go to work however once its dialed in firmware etc its very useful
Posted by a reviewer on Amazon
I could never get it dialed in correctly for the anycubic mega s but i used it watching the touch screen to see my bed variations and then dial in level from there
Posted by a reviewer on Amazon
Im sure the probe would work perfect if one takes the time to dial it in correctly
Posted by a reviewer on Amazon
If you are even remotely considering getting auto bed leveling get this product
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found