What does this mean?
More top products to consider
Transparency is key. This page may contain affiliate links. Find out how we make money.
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Highlights
Quality
Good upgrade for reducing calibration drift from vibration and i like the open design.
Parts fit and worked great on my crealityender-3 s1 printer with no problems.
My microswiss hot end leaked filament out the top of the heater block and the set screw stripped so i couldn't disassemble it.
Pid tuning was done before the first print as was checking/correctly setting the z offset for abl after installation.
Price
This bed leveling upgrade kit was a very good buy on sale.
I got this hotend since it was half the price of a new microswiss hotend and it's been working great with the microswiss direct drive.
Competitiveness
I replaced the 4010 hotend fan with a 4020 and have not had a repeat.
Overview
- How are reviewers describing this item?
new, fit, hot, good and enough. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 190 reviews as of our last analysis date on Mar 12 2025.
Helpful InsightsBETA
Posted by a reviewer on Amazon
My microswiss hot end leaked filament out the top of the heater block and the set screw stripped so i couldnt disassemble it
Posted by a reviewer on Amazon
As for compatibility the screws provided are the same length as the stock ones on the ender 3 original and the rubber stoppers are too big
Posted by a reviewer on Amazon
While they woll fit on there squished the springs dont push on them hard enough to allow the system to functionas you realistically only have one full turn of configuration
Posted by a reviewer on Amazon
Cutting the top 34 mm off the top of the stoppers make sure you get an even cut allowed mento install them without any issue
Posted by a reviewer on Amazon
Pid tuning was done before the first print as was checkingcorrectly setting the z offset for abl after installation
Posted by a reviewer on Amazon
July 9 2023 updatei did run into a heat creep blockage while printing pla in a closed enclosure and a 37c interior temp
Posted by a reviewer on Amazon
I put this on my ender 3 v2 and could tell it was an improvement when i saw how smoothly the filament was extruded
Posted by a reviewer on Amazon
My prints are coming out much better as well
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
