Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Bowden tube is an upgrade, of blue capricorn style ptfe material, measuring 45cm in total length, which is 60mm more in length than the stock ender 3 tube. Philips head screw on original for the thermometer replaced with flat head hex key. Even has co... Read More
Price alone is enough to buy, but the insanely impressive quality is a whole different story! Price is very good for what you get. Decent upgrade for the price.
Highlights
Quality
Great resolution and i was able to reuse bowden fittings.
Just installed this in my ender 3 v 2 and it was easy to do and it is printing very nice quality
The screws were stripped, the wrench was bent, and i couldn't for the life of me tighten anything to fit - and when i could, th... Read More
I use an ender 3v2 and it's been out of commission for months after an attempt to upgrade to an all-metal microswiss and brass ... Read More
Price
Really doesn’t get better for the money.
Price is very good for what you get.
At this price i bought this just to have on hand if my hotend needed repair so i could get back up and running asap.
Shipping
Was exactly what i was looking for and arrived earlier than expected.
After that group of parts shipped, the printer is still printing without clogs.
I had some parts that i had to ship out so i ordered this hot end.
Competitiveness
As mentioned by others you get extras with this purchase making this an even better deal.
Overview
- How are reviewers describing this item?
hot, new, easy, old and great. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 670 reviews as of our last analysis date on Mar 16 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
It was super easy to install and if using on the s8 i recommend removing the thermistor and wiring and just swapping them because the s8 needs a much longer wire than the ender 3 requires and the one included is sized for the ender not the s8 and swapping the wire is a pita
Posted by a reviewer on Amazon
So unless you know you’ve fried the thermistor too just swap them and keep the included wirethermistor as an emergency spare if needed
Posted by a reviewer on Amazon
The entire swap took about 15 minutes or less
Posted by a reviewer on Amazon
The hardest part was heating the heat block from my original one to allow it the screw to break free
Posted by a reviewer on Amazon
I hit it with a tiny torch flame just until the melted filament softened enough to be moved so a couple seconds max
Posted by a reviewer on Amazon
If you have some patience and take pics before you remove the old one youll be fine
Posted by a reviewer on Amazon
I have a voxelab aquila ender 3 v2 clone and ended up clogging the stock hot end my own fault didnt properly switch the it was working perfectly fine before that
Posted by a reviewer on Amazon
I was having a difficult time unclogging the hot end and felt like i was just wasting my time so on a whim i ordered this one to replace it
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found