Highlights
Quality
Auto leveling works very well and the remote viewing, pausing and status is really nice to have.
Once you get it setup and the right code in your slicer this makes bed adhesion perfect.
I have had this setup since late december, and i have not touched the bed screws since i did the initial level out of the box.
The connector plugs right into the factory port on the system board on the printer.
Shipping
They took care of it quickly and made sure i was taken care of.
Packaging/appearance
It came well packaged, and has a long enough wire to get it installed with the wire running inside the oem wire loom.
Competitiveness
Nice to see there are still companies out there like them!
Overview
- How are reviewers describing this item?
right, first, new, better and little. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 4 reviews as of our last analysis date on Mar 15 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Purchased this when i purchased my ender 3 v2
Posted by a reviewer on Amazon
The connector plugs right into the factory port on the system board on the printer
Posted by a reviewer on Amazon
It came with the metal bracket that mounts to my printer and a few others for different models
Posted by a reviewer on Amazon
Then you measure the offset of the probe measure distance from the print nozzle x and y went into the printer menu and told it to create a new mesh and the printer then started probing the bed in 15 different spots
Posted by a reviewer on Amazon
After the created the new mesh you tell your starting gcode to use the saved mesh and away it went
Posted by a reviewer on Amazon
I have had this setup since late december and i have not touched the bed screws since i did the initial level out of the box
Posted by a reviewer on Amazon
This crtouch or bltouch is a must have for any 3d printer
Posted by a reviewer on Amazon
I could never seem to get the bed to be level enough for really good prints