Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Blade is the best solution for cutting thin steel as i have seen. Used to cut corrugated steel roofing, a small project. Used this to cut metal siding for my garage.
Exceeded my expectations with clean cut and low vibration. No jagged edges or burnt steel. Not quite as smooth.
The blade works very well. Gotta love two day shipping too. Great blade so far. Satisfied with both uses. Best blade ever build.
Superior to grinding blades in every possible way. Lowered the blade speed to 1800 rpm by putting a smaller diameter pulley on its motor shaft.
Cons
Did not hold up well for cutting thin steel siding and roofing. Will be returning for a refund going back to cutting with snips.
Highlights
Quality
I am very impressed with the clean cuts delivered, and the accuracy; with no skating.
(29 gauge) very impressed with the smooth, clean cut.
Packaging/appearance
Had to sand the center area to remove the red slippery paint.
Competitiveness
For other blades, we have to do at least a small amount of de-burring but this blade leaves very very nice edges with no de-bur... Read More
Overview
- How are reviewers describing this item?
cut, metal, great, made and good. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 396 reviews as of our last analysis date on Jan 30 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
You will only get so many cuts out of it before the blade is done but i was cutting thick gauged roofing rpanels but made like 100 cuts or so before it dulled out
Posted by a reviewer on Amazon
After a few cuts i was then cutting two sheets at the same time
Posted by a reviewer on Amazon
No discoloration or rough edges
Posted by a reviewer on Amazon
Cuts the metal like butter and leaves a very very small burr
Posted by a reviewer on Amazon
There was no way the saber saw could cut corrugated steel sheets without drift
Posted by a reviewer on Amazon
It cuts as quickly as the saw would cut 14 in plywood and leaves a straight edge that looks like a factory edge
Posted by a reviewer on Amazon
I would strongly suggest that you need to wear eye protection preferable goggles as it throws off a lot of steel chips a bit smaller than salt grains and one of these in your eyes would be a serious problem
Posted by a reviewer on Amazon
The blade does state that it is not recommended for hard steel stainless steel and the like or nonferrous metals
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found