Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Dry box is excelente and do what it promises. It does what it’s designed to do, dry the filament, just no status. Great for most filaments but not nylon. Need to dry it for 24-48 hrs depending on the surrounding humidity.
Right now my dryer is displaying:48. This product is very affordable. I have 2 and it dose what it says.
Cons
My dryer shuts off continuously while trying to reach the right temperature. It goes into the er 3 error code after ten minutes of operation. The issue with it is it doesn’t move air around the filament to get the moisture out.
Highlights
Quality
This drier really improved the quality of the print and usability of the filament.
It has definitely improved the quality of my petg filament/prints.
I would recommend for us novices with the above stipulations.
Packaging/appearance
Comes with good packaging, box got bunged up from transport (ups hates our area so don't worry) and the thing was fine, no scra... Read More
A few hours in this, and the filament printed like a new roll straight from the packaging.
So my first unit had the heater resoldered right out of the box.
Competitiveness
Nice filament dryer, exact same thing as sunlu, it has a sunlu decal on the bottom so if it happens to be the best deal at the ... Read More
I print almost exclusively with petg which needs to be kept dry.
Overview
- How are reviewers describing this item?
dry, great, set, inside and found. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has detected that Amazon has altered, modified or removed reviews from this listing. We approximate total reviews altered up to 1811.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 501 reviews as of our last analysis date on May 8 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Had a lot of problems with an almost full reel of abs filament
Posted by a reviewer on Amazon
What is confusing is how to operate the dry box
Posted by a reviewer on Amazon
But what they do is not well explained
Posted by a reviewer on Amazon
You probably can figure out just pressing them or go to youtube see some reviews
Posted by a reviewer on Amazon
It reaches 53°c in two areas at the bottom but is not like is very well insulated to keep it warm completely and use less energy
Posted by a reviewer on Amazon
I print almost exclusively with petg which needs to be kept dry
Posted by a reviewer on Amazon
They should save the paper and not include them
Posted by a reviewer on Amazon
Just set the time and temp and forget
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found