Pros & Cons
Pros
The reels inside allow for smooth movement, so the reels don't seem to go into snag mode since it allows pretty free movement without reel pushback. After spending hundreds of * mods for my ender 3 this is the only purchase that has actually drastical... Read More
Easy to use timer or just on. Although the levels are a bit weird and so is the timer since they don't read in specific durations that make sense unless you read the manual. Regarding the positioning of the dryer box features. The results vary.
Highlights
Quality
Product works as advertised, purchased so i could run larger spools on my printer.
Don't use default settings and this is quality filament.
Packaging/appearance
The angle and height the filament comes out of the ebox lite is low enough to load into my tiny, bottom loading tina 2/cadet pr... Read More
I have had the ebox lite totally recover abused and waterlogged pla that continuously popped about two or three times a second ... Read More
Competitiveness
If you check the manual you'll see these correlate to different temperatures for things like pla, petg, nylon, etc.
On an anycubic mega, i'm using 235c print temp, 50c bed temp, with a layer of glue stick.
Overview
- How are reviewers describing this item?
great, dry, lite and quality. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 128 reviews as of our last analysis date on Jul 22 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
On an anycubic mega im using 235c print temp 50c bed temp with a layer of glue stick
Posted by a reviewer on Amazon
I have had the ebox lite totally recover abused and waterlogged pla that continuously popped about two or three times a second for hours during a print
Posted by a reviewer on Amazon
I have also had it not help at all with pla that has issues adhering
Posted by a reviewer on Amazon
Sometimes filament goes bad for other reasons or is just profoundly low quality right out of the box
Posted by a reviewer on Amazon
Finally regarding the positioning of the dryer box features
Posted by a reviewer on Amazon
Some filament dryers have the filament come out too high to be readily compatible
Posted by a reviewer on Amazon
Additionally in my opinion the controls should be perpendicular to the side the filament comes out of instead of directly below the filament exit point