What does this mean?Pros & Cons
Pros
The reels inside allow for smooth movement, so the reels don't seem to go into snag mode. They're smooth, so not a lot of tension on your extruder gears. Once you get this stuff dialed in, it prints out great parts.
Twenty-seven hours or more has been required in some instances (with just pla) to get it back to prime. Although the levels are a bit weird and so is the timer since they don't read in specific durations. It is easy to setup.
The angle and height the filament comes out of the ebox lite is low enough to load into my tiny, bottom loading tina 2/cadet printer without problems. Finally, regarding the positioning of the dryer box features.
Highlights
Quality
Product works as advertised, purchased so i could run larger spools on my printer.
Don't use default settings and this is quality filament.
Packaging/appearance
The angle and height the filament comes out of the ebox lite is low enough to load into my tiny, bottom loading tina 2/cadet pr... Read More
I have had the ebox lite totally recover abused and waterlogged pla that continuously popped about two or three times a second ... Read More
Competitiveness
If you check the manual you'll see these correlate to different temperatures for things like pla, petg, nylon, etc.
On an anycubic mega, i'm using 235c print temp, 50c bed temp, with a layer of glue stick.
Overview
- How are reviewers describing this item?
great, quality, dry and tried. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 161 reviews as of our last analysis date on Aug 23 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
On an anycubic mega im using 235c print temp 50c bed temp with a layer of glue stick
Posted by a reviewer on Amazon
I live in florida and ive always had issues with pla getting brittle over time and snapping coming off the roll or when the printer sitting idle for too long all the filament in my teflon tube is cracked into 67 pieces when i go to use it again
Posted by a reviewer on Amazon
I thought it was just because i was printing intermittently and it would get old
Posted by a reviewer on Amazon
I have had the ebox lite totally recover abused and waterlogged pla that continuously popped about two or three times a second for hours during a print
Posted by a reviewer on Amazon
I have also had it not help at all with pla that has issues adhering
Posted by a reviewer on Amazon
Sometimes filament goes bad for other reasons or is just profoundly low quality right out of the box
Posted by a reviewer on Amazon
Finally regarding the positioning of the dryer box features
Review Count History
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
