What does this mean?Pros & Cons
Pros
The finish is amazing and smooth. The filament still oozes pretty noticeably, but any issues caused seem to easily clean up post print. Hardened steel nozzle is a must, i recommend the nozzle x. Prints easily without much warping on a glass print bed ... Read More
Purchased after having problems with overture's easy nylon. It's also a very cheap upgrade.
Cons
Be very careful trying to trim brims. Insane amount of oozing from esun epa6-cf. It seems like there are a few "chunks" of carbon that are too large and get stuck in the nozzle.
Highlights
Quality
Eventually baking in the oven fixed quality issues, and is printing very well now.
Very tough if you print it on the high end of the recommended range, but like another review said overhangs past 250ish have a ... Read More
Print quality is great if you dry out for several days!
These are not issues with the brand, but rather the material.
Packaging/appearance
I typically run this at 260c on the hotend, 80c on the bed with raft turned on.
Competitiveness
Most under $600 printers are not well equipped from factory with a hotend that can run continuously at 260c without damage bec... Read More
I normally swear by esun, but this has been an expensive waste of money.
I'm using a creality cr-10 v2 that's upgraded with a direct drive hemera equipped with a hardened steel 0.
Printed on a qidi ifast at 245, bed at 90.
Overview
- How are reviewers describing this item?
material, great and little. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 114 reviews as of our last analysis date on May 25 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Im using a creality cr10 v2 thats upgraded with a direct drive hemera equipped with a hardened steel 0
Posted by a reviewer on Amazon
I also slowed the print down to 30mmsec overall speed in cura
Posted by a reviewer on Amazon
Just remember to dry it thoroughly turn the temp up and the speed down
Posted by a reviewer on Amazon
You have to take into consideration that there are solid particles in the squirting goo
Posted by a reviewer on Amazon
These are not issues with the brand but rather the material
Posted by a reviewer on Amazon
I printed this with several diameters and the smaller the diameter the more it clogged
Posted by a reviewer on Amazon
All that being said one part i printed was stuck in my bench vise while i attempted to break it
Review Count History
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
