Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Excess condensate will be pumped out the window along with the hot air exhaust.
Cons
If you get a big enough air bubble it stops and you need to help start it again. The pumps pump for a few hours and then stop pumping. They burn out within a week.
Highlights
Quality
These 2 pumps and 2 momentarily “toe buttons” (where foot levers use to be), made life flow again.
Brushless leak proof easy to clean long life efficient etc.
Removal of the 4 screws on the pump face revealed biological material in the impeller which was easily removed and pump easily reassembled.
The suction power rating in my review is left blank because this type of pump does not suck, it pushes liquid.
Price
But what a great value and a life saver!
These are great for the price point.
I am very happy two for only $13.
Shipping
$300 to get 2 new ones shipped to fiji.
Not a lot of free shipping to fiji.
Packaging/appearance
They look pretty well sealed so splashing shouldn't be a problem.
Competitiveness
I measured the flow rate at full voltage at just over 3 liters per minute which is less than they are rated at (4 l/min) in the... Read More
Overview
- How are reviewers describing this item?
great, little, few, small and good. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 269 reviews as of our last analysis date on Jul 4 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
They do not self prime and can loose prime from air bubbles
Posted by a reviewer on Amazon
They will pump about 7ft8ft high although have to already be pumping to do so
Posted by a reviewer on Amazon
Haven’t tested longevity but do not foresee any issues arising
Posted by a reviewer on Amazon
Pump was working fine but then stopped flowing so i connected it to a bench power supply to see if it was burned out
Posted by a reviewer on Amazon
Saw that it was drawing only a few ma most of the time but once every few seconds it would draw something like 150ma
Posted by a reviewer on Amazon
The reason was that something was blocking the impeller and the pump was sensing the overcurrent fault and retrying every few seconds
Posted by a reviewer on Amazon
The pump was then fine so the problem was that blockage
Posted by a reviewer on Amazon
These worked ok for my 34scientific34 application but they dont lift water to the stated height
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found