Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Cons
This has the dubious distinction of being perhaps the single most frustrating product i have ever tried to use. Tried hot water, unclogged the hole, does not matter. Plugged after a minute of using. Such a disappointment.
The nozzle is poorly-designed and it's apparent that whoever designed it never used a rattle can in his life. The material is too thin and sputters badly, goes on with various size lumps and then leaves voids when dry. It doesn't spray properly, it le... Read More
Highlights
Quality
Regulating texture size nozzle gives very good results
I got the best results by soaking the can i a bucket of hot tap water for 10 minutes before shaking and spraying a test pattern... Read More
First put the can in warm water 5-10 minutes, then shake like there's no tomorrow.
Works good but difficult on to use on ceiling
Price
This product was just what i needed for a small wall repair and was cheaper than the big box store
Had to do some sheetrock repair this stuff worked wonderful and was a good price.
The bad part is how the price continues to go up.
My only issue is that you pay a good amount for so little.
Competitiveness
This one worked better than the 2 i got from the local hardware store.
Overview
- How are reviewers describing this item?
great, down, good, first and easy. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 901 reviews as of our last analysis date on May 23 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Read and follow the instructions carefully and then do this1
Posted by a reviewer on Amazon
Shake the can well as directed on label2
Posted by a reviewer on Amazon
Run some warm tap water in the sink and put the can under the running water so that the contents warm up3
Posted by a reviewer on Amazon
Before applying to the wall mask off the area around where you are going to spray using painters tape and plastic to protect the rest of the wall in about a 1 foot area all around6
Posted by a reviewer on Amazon
Once it sets for a couple of minutes use a thin putty knife to remove any texture that is too thick8
Posted by a reviewer on Amazon
Repeat the process until you get the look that matches the rest of the wall9
Posted by a reviewer on Amazon
You can paint the wall once the coating is thoroughly dry
Posted by a reviewer on Amazon
Mine came damaged but i have used it before
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found