Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Clean prints every time. It's like it's abs filament. Set temperature to 10°c cooler than what i usually run pla. Ran this on a fokoos odin 5 f3 at 200c/60c bed.
I am loving the meta pla, my only issue is the color. Prints great with the specified parameters. The colors are very sharp.
Highlights
Quality
Whether you are making something more detailed and intricate or something simple, the print quality is really great.
This filament has produced great results on my printer that has been dialed in, for curiosity i tried it on a newer printer tha... Read More
The quality of filament can affect your prints no matter how well dialed in it is.
I've seen other 3-d filament in this price range and the quality was not as good as jayo.
Price
First, the price is about in the ballpark of other budget brands going by weight alone.
Packaging/appearance
Seems to be consistent diameter, no impurities.
Competitiveness
I got pretty good results at 170°c.
Printed a few models just fine after getting it dialed in.
I am working with a makerbot replicator.
65kg you are looking at roughly 16$/kg - on par with most mid-range 1kg spools.
Overview
- How are reviewers describing this item?
good, great, cardboard, little and quality. - Our engine has detected that Amazon has altered, modified or removed reviews from this listing. We approximate total reviews altered up to 1317.
- Previous analysis of this listing was an D grade.
- Our engine has profiled the reviewer patterns and has determined that there is high deception involved.
- Our engine has analyzed and discovered that 21.2% of the reviews are reliable.
- This product had a total of 276 reviews as of our last analysis date on Mar 30 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
This was the first filament ive had really bad stinging on with my printer though i havent used too many
Posted by a reviewer on Amazon
Out of the box i tossed it into a dryer at 45°c for 5 hours and i recorded a weight drop of 2g
Posted by a reviewer on Amazon
Usually this would mean the filament shed a lot of water but seeing as how they use a cardboard spool and cardboard is far far more hydroscopic than filament im guess that weight drop was primarily water weight in the cardboard
Posted by a reviewer on Amazon
Measuring the filament diameter with my calipers i consistently came away at 1
Posted by a reviewer on Amazon
Calibration cubes done in 20 minutes yielded accurate size dimensions and stability except in the corners slight bulging from speedi was expecting at higher than normal speeds sliced in cura
Posted by a reviewer on Amazon
Temperature however can be an issue
Posted by a reviewer on Amazon
If you dont print at or below around 190 you are likely to get excessive stringing
Posted by a reviewer on Amazon
First the price is about in the ballpark of other budget brands going by weight alone
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found