Posted by a reviewer on Amazon

Took a few trial and error connections but got it working

Posted by a reviewer on Amazon

Now in the stairwell the lights will come on automatically if you open the door at the top or bottom of the stairs

Posted by a reviewer on Amazon

Now my light is turned on automatically when motion is detected from both ways and turned off when there is no motion is detected

Posted by a reviewer on Amazon

I decided to go with these after unsuccessfully trying legrand can’t use two cuz they cancel each other out and also reading that lutron doesn’t support two either

Posted by a reviewer on Amazon

The ipv0r is not a load bearing switch just a remote meaning it cannot be installed and won’t power up if you install it on the line side

Posted by a reviewer on Amazon

The remote sends the signal to the load bearing ips15 on the line side instead

Posted by a reviewer on Amazon

As long as you have the white neutral and the lines and loads correct the switches will be powered on as shown by the leds even if runnerstravelers are wrong

Posted by a reviewer on Amazon

The manual switching worked and so did the auto off