Posted by a reviewer on Amazon

It didnt have any crosstalk between output 1 and output 2

Posted by a reviewer on Amazon

Ive tried a couple of switches before but they either had a bad picture or passed video and not audio correctly

Posted by a reviewer on Amazon

O my old sceptre 42 sometimes wont relock after a switch and i have to switch off and back on to get image

Posted by a reviewer on Amazon

This is not a perfect productbut it is about the only solution and works great after simple tweaks manual is useless of course

Posted by a reviewer on Amazon

Eg if aprojector1processor is in use a second command is sent 500ms later with the bmonitor4ud9004 combo that way b monitor does not end up getting the same input as the aprojector if it so happened that it was earlier in use

Posted by a reviewer on Amazon

I do experience some lag from time to time when switching devices but nothing outside of expectations

Posted by a reviewer on Amazon

I have not done any research to figure out if this small problem could be solved

Posted by a reviewer on Amazon

The ir sensor seems like it isnt sensitive enough sometimes because i need to repeatedly send it a signal to switch inputs but other than that it works great