Posted by a reviewer on Amazon

The included instructions are almost useless

Posted by a reviewer on Amazon

Had to remove the interior back panel of the tailgate 2 bolts on the passenger bottom corner of the tailgate the rest is held with clips

Posted by a reviewer on Amazon

Remove the original passengerside license plate light cover and replace with the camera

Posted by a reviewer on Amazon

Had to squeeze the video power cable through the hole that the light cover clips into very tight fit

Posted by a reviewer on Amazon

The extended black wire was connected to my car radios black ground wire and the red wire that is in the video cable was connected to the car radios reverse purple white stripe sensor wire backup lights

Posted by a reviewer on Amazon

The wires ran from the camera to the driver side upper corner of the tailgate out through the hole covered with a rubber cap next to the boot back into the car through a similar hole i cut a slit in both rubber caps for the wire to feed through down towards the taillight then forwards beneath the side trim to the back seat had to partially pop out the trim then i tucked the wires between beneath the trim and the carpet all the way to the hood release lever from there the wires were threaded under the dash to the radio

Posted by a reviewer on Amazon

The only negative is in bright sunlight the image is too white

Posted by a reviewer on Amazon

You can still see but the picture is washed out looking