Pros & Cons
Cons
The small screws are very soft and the heads strip out. No tool was included.
Highlights
Quality
Its clear the parts are machined out of high quality materials, and this will last me longer than the table saw.
This device is easy to set up and start using and allows you to quickly switch between inches and millimetres.
Measuring from table saw miter slot it says that the current blade is off by 19 thousands which seems about right.
Seems accurate enough for general home workshop use, it identified some run out on my table saw blade and alignment of my fence... Read More
Price
This is awesome value for money if you consider how pricey these can get.
I've wanted one of these for ages to try and dial in my table saw but they've always seemed way too expensive to justify buying.
Overview
- How are reviewers describing this item?
cross, set, included, easy and fit. - Our engine has profiled the reviewer patterns and has determined that there may be deception involved.
- Our engine has determined that the review content quality is low.
- Our engine has analyzed and discovered that 60.0% of the reviews are reliable.
- This product had a total of 27 reviews as of our last analysis date on Jul 18 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Measuring from table saw miter slot it says that the current blade is off by 19 thousands which seems about right
Posted by a reviewer on Amazon
It does have some wobble to it
Posted by a reviewer on Amazon
When i measure the same spot on the blade it says it is off by 5 thou
Posted by a reviewer on Amazon
The good news is that the fence is also off by 5 thou over the same length
Posted by a reviewer on Amazon
So if the measurements are true thats close enough for woodworking to me
Posted by a reviewer on Amazon
I had no troubles with the gauge itself
Posted by a reviewer on Amazon
The threads on the backplate and the crosspiece were drilled and tapped correctly
Posted by a reviewer on Amazon
The adjustment knobs only make the crosspiece go up and down there is no way to adjust the width to fit exactly in the miter slot