What does this mean?Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
I keep mine in a tupperware container half full of mineral spirits to keep it lubricated. Just recommend taking some very fine bead blast bead and surfacing it on a flat piece of steel with some oil or solvent.
Cons
You never know - some folks are just unreasonable. This stone isn't anywhere close to flat. It's simply too far out of spec to work. Sadly, the 1-star reviews are spot on.
Highlights
Quality
Great for kitchen knives, keeps blade usefully sharp with just a quick touch no oil, acts as much as a burnish as metal cutting.
These stones are great for removing high spots off die plates, burrs form reference surfaces without affecting the surface.
I should of gotten the 8 inch there both made in mexico sadly get their oil i use it out kurt vise and haas vf1 table seems sma... Read More
This particular stone i wanted for rough stoning machines surfaces where i want to knock off burrs etc before mounting an angle plate.
Shipping
I bought three of them, two of them arrive normally and i am using them happily.
Packaging/appearance
The packaging worked so it arrived in good condition.
However, it's very prone to becoming packed with material when stoning aluminum.
Competitiveness
This norton stone works better than any arkansas stone that i have used.
Overview
- How are reviewers describing this item?
stone, great, good, flat and sharp. - Our engine has profiled the reviewer patterns and has determined that there may be deception involved.
- Our engine has determined that the review content quality is low.
- Our engine has analyzed and discovered that 70.1% of the reviews are reliable.
- This product had a total of 405 reviews as of our last analysis date on Aug 3 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
One of if not the best table stones out there
Posted by a reviewer on Amazon
Remember to include some high purity usp mineral oil or similar if you’re stoning your cnc machines table and don’t press too hard and don’t stay in one spot too long
Posted by a reviewer on Amazon
If using on thicker metal as found in an axe start with the brown side for dulled axes and then move to the orange side or just start with the orange side for an axe that needs a sharp fine edge put back on
Posted by a reviewer on Amazon
I have not tried it on a sushi knife but you might want to get something with an even finer surface for that
Posted by a reviewer on Amazon
The previous owners did not appear to be careful about maintaining the table as there were a lot of nicks and dropped tool marks
Posted by a reviewer on Amazon
I should of gotten the 8 inch there both made in mexico sadly get their oil i use it out kurt vise and haas vf1 table seems small i will get the 8 inch later
Posted by a reviewer on Amazon
Just recommend taking some very fine bead blast bead and surfacing it on a flat piece of steel with some oil or solvent
Posted by a reviewer on Amazon
It doesnt wear out a lot so the stone geometry wont change much
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
