Novamaker is our “go to” for filaments, in particular their tpu. I highly recommend this tpu, as it's not super squishy. This stuff seems to scrub the old filament out much quicker. Stock ender 3 v2 with bowden setup.

Gaskets for glue bottles are printed at 100% infill to replace degrading foam gaskets. Higher on the recommended temps for bed heating and nozzle worked better. I use 255c nozzle and 75c bed and it prints well.

No blockage. Please don't risk it. I'm not the type to just bash a product. Even though i am 6 months beyond the return window, they let me send it back for a refund!

bad, pulls off bed after a few layers and sticks to nozzle. Then it fills the hotend silicone insulator with plastic. As a result the stringing is worse than typical petg.

Parts look good but they are extremely brittle. More brittle than the same part printed in pla. The parts just shatter.

The spool, the packaging, and desiccant only weigh 75g if it is a 1kg spool. Spool recommends a hotend temp of 220-260c - if you go over 240c it strings badly. If it goes over 250c it leaves brown burnt blobs of plastic.