Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
The color of this pla is hot! It pops almost like neon. It's made with usa high purity raw material, is is extremely good fracture toughness.
Comments below still apply, take the time to dial in your settings and this prints well. Seems stronger then normal pla but prints at same settings. For the speed it was printed at, the quality is great!
The texture and stiffness of the line is higher than other filaments i have worked with and is almost wavy coming off the spool. It also bridges well, no globs and zero stringing.
This always seems to lay out an excellent first layer adhesion reducing shrinkage abs warping or curl and print failure. This filament has pretty good bed adhesion on all the surfaces i tried (reg glass, pei, flex plate, textured glass) the only negat... Read More
Cons
The filament thickness is not consistent. The filament diameter is so inconsistent. That inconsistency leads to poor prints and much more visible and inconsistent lines on the print.
I unwound about 20 feet, but issue returned. Returning for refund. Do not buy.
Highlights
Quality
My first print came out great and the adhesion and print quality is comparable to much more expensive filaments.
I was pretty impressed with the strength and printability .
Though keeping the x-plus top and sides open was recommended for standard pla, i actually had to keep the top and door closed w... Read More
I only use monoprice pla+ since the quality has been consistent.
Price
Price was really good and it is made in china, so i had low expectations but i think if you run it a little hotter than normal ... Read More
Packaging/appearance
Put this filament to work the moment i got it out of the package.
Competitiveness
I used a prusa i3 mk2/s, and this filament works well.
It is different than pla+ from polymaker by quite a bit.
Helpful InsightsBETA
Posted by a reviewer on Amazon
But had zero issues when it was fresh and for sure dry
Posted by a reviewer on Amazon
And read the directions mine says print temp range is 200 to 230 on the label right on the spool
Posted by a reviewer on Amazon
Made sure the bed was very clean
Posted by a reviewer on Amazon
When i was having problems with it warping or curling up i had the bed too hot
Posted by a reviewer on Amazon
And if it seems like its sticking and things are going well
Posted by a reviewer on Amazon
I really dont care but if your project needs a true black this probably isnt the best choice
Posted by a reviewer on Amazon
Careful using this it is ridiculously sticky
Posted by a reviewer on Amazon
Like i full on peeled off the first layer trying to get it off the build plate
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found