Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Beautifully red, slightly translucent. If i have any complaint, it's that it came on a spool.
Fan off for everything but bridges/overhangs. Stock ender 3 v2 with bowden setup. Great filament for my ender 3v2.
Cons
Not a single success in seven attempts. It is deceiving. I’m not the type of person to just bash a product.
Strings pretty bad, even after drying. Corners like to lift, which the printer will then hit and knock the print free of the bed. This stuff only prints well in vase mode or 10mm/sec regardless of any other settings.
The coating is coming off, and it does not seem to melt at the same temperature as the filament. I dislike the oily beige brown discolored black tpu 95a filament.
Highlights
Quality
The print quality is very good, no issues with adhesion, the spool is wound well and it appears to be the correct hardness.
It seemed like a good price and was a good quality product.
It was a gift and i wouldn't return it anyway, but definitely a quality control issue.
I have an ender 3 s1 pro with the creality sonic pad (klipper).
Price
The price is the best for the amount provided.
The price is nice, but i think if i try some more petg, it'll be some with a little bit bigger cult following.
Packaging/appearance
There is tiny micro bubbles in the filiment here and there.
I had to adjust my extruder to reduce the gap between the wheel&gear and the top of the heatbreak.
I put this spool strait from the packaging to the printer without letting go of the end.
Competitiveness
I printed rey’s lightsaber using the yellow petg for the blade.
Went blue tape 110c bed temp 227c extruder same makerbot settings.
Overview
- How are reviewers describing this item?
good, first, black, color and same. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 1,912 reviews as of our last analysis date on Sep 15 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I have found that i had a bad roll
Posted by a reviewer on Amazon
I switched to another out of the three i purchased and it is a wonderful filament
Posted by a reviewer on Amazon
This will not clear a clog this is not designed for cold pulling
Posted by a reviewer on Amazon
It may help because it does lubricate the hotend so be careful what you touch after handling because your handsfinger may
Posted by a reviewer on Amazon
Higher on the recommended temps for bed heating and nozzle worked better
Posted by a reviewer on Amazon
Run this filament slow unless you have lots of experience running soft filaments
Posted by a reviewer on Amazon
It has a habits of escaping the extruder gears if fed to quickly
Posted by a reviewer on Amazon
Had best luck with standard brass nozzle polished interior
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found