Highlights
Quality
I have 6 machines with this product.
Allowing that to dry, it goes fast with the heated plate.
Price
Replaced a very sticky stock bed for cr10s pro v2 with this flex bed and it's great.
Packaging/appearance
The first time i ran it i found that the total thickness of the 2 pieces was enough to block the proximity sensor to not see th... Read More
Competitiveness
All in all i would buy again (i may have to soon judging by the wear marks seen in 2nd pic), i don't know that this is really t... Read More
And since its a 2pc magnet then if/when you need a replacement you can simply just swap it out.
Overview
- How are reviewers describing this item?
surface, good, great, flexible and first. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 84 reviews as of our last analysis date on Nov 23 2021.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Its a little troublesome getting on flat without air bubbles and the bending required to remove prints that are pretty flat leaves creases which affect the next print
Posted by a reviewer on Amazon
If completely cooled prints pop off easily however if your print fails early on and you only have a couple of layers down you will have to sacrifice another print overtop to remove the extruded filament
Posted by a reviewer on Amazon
No instructions on cleaning the surface
Posted by a reviewer on Amazon
And since its a 2pc magnet then ifwhen you need a replacement you can simply just swap it out
Posted by a reviewer on Amazon
Anyway it forms a dry film on the surface its applied to
Posted by a reviewer on Amazon
I bought the pva mould release agent at fibretek in vancouverburnaby bchttpwww
Posted by a reviewer on Amazon
With the top mat being flexible there is never a problem getting it to release you simply roll the mat away from the printed item
Posted by a reviewer on Amazon
The first time i ran it i found that the total thickness of the 2 pieces was enough to block the proximity sensor to not see the bed in time to prevent the hotend nozzle to bury itself in the 2 mats