Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Cons
Lasted 1 11 hour print before heavy vibrations. It lasted.
Highlights
Quality
This was a great and quick product to help us get back on track with our 3d printing.
Spliced wires mid-loom and use heat shrink tube to isolate the new connection.
The wire failed at the point where it was soldered to the fan motor on the hot end.
Attempted to res-solder it back however the connection points were too small to do so with the limited amount of room available.
Overview
- How are reviewers describing this item?
great, hot, new, perfect and neo. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 335 reviews as of our last analysis date on Sep 7 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I did hot glue my wires near the fan so they don’t short out during service
Posted by a reviewer on Amazon
It took some wiring skills to get it back in place
Posted by a reviewer on Amazon
Little more fan noise than stock
Posted by a reviewer on Amazon
The wire failed at the point where it was soldered to the fan motor on the hot end
Posted by a reviewer on Amazon
Attempted to ressolder it back however the connection points were too small to do so with the limited amount of room available
Posted by a reviewer on Amazon
Works fine now but i am overly cautious now when removing fan shroud to fix hot end which seems like a weekly ordeal on a ender 3 v2 neo
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found