What does this mean?Pros & Cons
Pros
The color is simply stunning and gives my 3d prints a beautiful, metallic finish.
Smooth extrusion, zero issues with adherence on pei, and surprisingly low stringiness for petg. Good layer adhesion, the parts are nice and strong.
Highlights
Quality
Good product, works great on prusa and creality machines.
It has the same quality as polymaker at a lower price point.
I print with the following settings: retract settings on in slicer, glass bed surface, 0.
Packaging/appearance
Making the move from pla to petg was a bit of work but i wouldn't go back.
Competitiveness
I’ve never used their petg filament before, but i like it a lot.
I've had no crossover incidents and it generally prints a bit less stringy than other petg.
Like other petg filaments, it is very resistant to adhesives.
I use this and matterhacker standard petg filament and the results are basically the same.
Overview
- How are reviewers describing this item?
quality, great, good, same and color. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 14,204 reviews as of our last analysis date on Aug 8 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
It would start out ok but around the third layer clogs would start and unless i watched it like a hawk and cleared them the print would fail other times it would sail through with no problems change the tip change the temp dry the filament level clean etc
Posted by a reviewer on Amazon
I disassmbled the machine ender 3 pro turns out my heater block in the print head was loose it was going up and down changing the length between that and the feed just enough to shorten the distance allowing the heat to travel up into the print head melting the filament too early causing clogs other times there would be consistent pressure pushing the heater block down and it would be fine resulting in a good print and my continual confusion
Posted by a reviewer on Amazon
Removing the supports and a little sanding get rid of all that
Posted by a reviewer on Amazon
Then i came across this as an amazon deal and jumped at the 1kg spools
Posted by a reviewer on Amazon
Immediately it all went down hill and i couldnt get it dialed in with my limited knowledge
Posted by a reviewer on Amazon
I wrote this product off for almost a week before i noticed that i needed to read the print vs people opinion
Posted by a reviewer on Amazon
Often when using new filament there are adjustments that need to be made to get the perfect stick of a project this was not the case
Posted by a reviewer on Amazon
I will be purchasing other colors and try some other types soon enough
Review Count History
Price History
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
