What does this mean?Pros & Cons
Pros
Tpu works well on ender 3 pro upgraded with direct drive, and dual gear extruder. Runs cooler on nozzle temp than other tpu i have used.
Adhesion is very strong, even after the bed has cooled down. It prints a little stringy so a little finishing is required but that’s typical of a very soft filament. Adhesion to the ender-3 pro's mag bed isvery strong cold at start.
The tpu itself is very good, has very good flexibility, stretch, consistency and has a great colour. Great flexibility and great (consistent) colour.
Cons
Sometimes it works but most times it either clogs the nozzle or jams the extruder. Also adhesion is pretty bad to itself.
Highlights
Quality
I will be ordering more in the future from overture and possibly pla as well, as the print quality is outstanding with these spools of tpu.
This was my first print using my normal pla settings just with retraction speed turned down, other than needing to dial in stri... Read More
My prints lack a bit of quality due to bowden setup.
They were different level of the flexiblity, in which is hard to use one estep to all.
Competitiveness
Also came with a 15x15 stick-on textured print surface!
I've got a creality dd upgrade on hand but wanted to try printing tpu without doing the upgrade first and am happy to report th... Read More
Since its softer than the sainsmart tpu i found that the if the tension of the gears is too high the gears with deform the fila... Read More
I mainly print on a prusa i3 mk3s so what i found is that the filament was tangling between the extruder gears.
Overview
- How are reviewers describing this item?
great, quality, good, flexible and tried. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has analyzed and discovered that 76.2% of the reviews are reliable.
- This product had a total of 277 reviews as of our last analysis date on Dec 28 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I mainly print on a prusa i3 mk3s so what i found is that the filament was tangling between the extruder gears
Posted by a reviewer on Amazon
Since its softer than the sainsmart tpu i found that the if the tension of the gears is too high the gears with deform the filament causing it to escape the gears and knot up
Posted by a reviewer on Amazon
Simply speaking just lower the tension of the gears to as loose as possible and it will print great
Posted by a reviewer on Amazon
It was ok but more like soft plastic than the soft rubber feel that i wanted and looked closer to black crystal
Posted by a reviewer on Amazon
And the tires look like black rubber tires instead of looking plasticky
Posted by a reviewer on Amazon
They were different level of the flexiblity in which is hard to use one estep to all
Posted by a reviewer on Amazon
In the beginning that my print is very difficult to get exactly the right path
Posted by a reviewer on Amazon
I face a lot of trouble of testing print
Review Count History
Price History
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
