Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
There are instructions included, but they could be clearer. The * is designed to be held against the top and the side of a door or drawer. My cabinet doors have a wide bevel around the edges.
The guide holes accept a 3/16 bit, which is the norm for fitting #8 metal screws. The guide set screws seem to be of high quality as well. It was used for a new install of both knobs and cup type handles.
It will make installing cabinet handles much easier. Little tricky to setup but in a few minutes in can be done. Works well for the price.
Cons
The template is defective so the bottom hole is 1/8 of and inch off every time! Will be sending it back. This makes using the holes on the tool as guides while drilling completely impossible; there is no way to use those as drilling guides without dis... Read More
Highlights
Quality
Quality enough material that i think is just fine for a home project person like me.
I am very pleased with how our knobs came out.
Price
Simple simple simple for the cost i paid.
Just what i expected for a great price.
Overview
- How are reviewers describing this item?
made, easy, great, accurate and set. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 1,004 reviews as of our last analysis date on Dec 30 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
If i did this more often i would buy a better one
Posted by a reviewer on Amazon
This made keeping the device in one place pretty difficult
Posted by a reviewer on Amazon
Once i figured how to hold it steady i used a pencil sharpened to an extra long point to reach through the punch holes
Posted by a reviewer on Amazon
Make sure to punch a good sized dent so your drill bit doesnt wander
Posted by a reviewer on Amazon
Id rather make pencil marks and then punch rather than clamping and unclamping every 15 seconds to hold the jig
Posted by a reviewer on Amazon
However the inch markings were accurate as confirmed by an american tape measure
Posted by a reviewer on Amazon
In other words the vertical ruler has 17 graduations per inch where each equally spaced 116th mark being exactly 117th of 116th too small
Posted by a reviewer on Amazon
Accuracy had to dock it 117th of 116th of a stareasy to use oh yeahvalue for money depends on how you view that extra 116th
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found