Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Cons
The steel is actually too thin; it gets jammed between the piston and cylinder, and then you got a problem. Couldn't get it tight enough to stop the rings from popping out while tapping the piston into the cylinder. Scratches your surface and doesnt l... Read More
Ratchet lock can't hold enough pressure to compress rings. Compression bands are not attached to the compressing sleeve. Spring steel that is supposed to compress the piston rings is so thin that it bows out without fully compressing the rings.
Highlights
Quality
Holds the piston firmly and very easy to adjust to get the correct compression and alignment.
Keep it oiled, and it will last a lifetime!
Liberal oil on inside of compressor before you even start.
Have slammed all kinds of pistons through this thing.
Price
It was easy to use and for the money you can't beat it.
Would buy again though, for the price.
For the money it’s not bad but when ya start to get sweaty or greasy hands it can get hard to use but for the dollars it’s a good tool.
Overview
- How are reviewers describing this item?
great, first, made and good. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 956 reviews as of our last analysis date on May 2 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I just had a little predator clone i was teplacing the piston in
Posted by a reviewer on Amazon
I actually seated that hoe first try
Posted by a reviewer on Amazon
Hopefully it works havent used yet
Posted by a reviewer on Amazon
They last about a year there but would probably last much longer for personal use
Posted by a reviewer on Amazon
Have slammed all kinds of pistons through this thing
Posted by a reviewer on Amazon
Would not have been able to install piston rings without this tool
Posted by a reviewer on Amazon
Only dislike is the unwinding mechanisim if you unwind this thing without holding it properly it could unwind fast and endup cutting you with its sharp edges so watch out for that
Posted by a reviewer on Amazon
It did the job i needed it to but i had a hard time keeping it square unlike some other ring compressors ive used over the years
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found