Pros & Cons
Cons
The bulb side is good but the other side doesn't lock which make it useless. Connector plugs are too short to snap on factory socket. Sending them back asap.
Highlights
Quality
For about 1-1/2 hours work i am very pleased and the h13 lights work as they should.
This product fixed the flickering problem with the led headlights we purchased for our dodge 3500 2009
All the bad things are true about this product.
On one of our vehicles i had an issue with the head lights.
Competitiveness
Easy to install have problems with wife's explorer led light showing on dash head light out with these no more code thanks cost... Read More
If you own a ram with canbus these are a must.
Tried at least 3 other canbus resistors and this was the only one that work on a 2007 ford explorer.
Overview
- How are reviewers describing this item?
hot, high, great, easy and plastic. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 493 reviews as of our last analysis date on Sep 26 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
This product get extremely hot whenever in use
Posted by a reviewer on Amazon
I plugged it in and no later than 2 seconds later burnt my hand holding it trying to mount it so it doesn’t burn or melt anything
Posted by a reviewer on Amazon
Make sure to keep away from anything plastic or anything that will melt
Posted by a reviewer on Amazon
I first installed led headlights turned them on and the started flashing and went out after several seconds lights out
Posted by a reviewer on Amazon
Then check engine ignition light went on and the truck acted like the battery was almost dead when starting
Posted by a reviewer on Amazon
The factory sockets for my hid bulbs were brittle because of the hid bulb heat so used wire tie to secure sealight harness plug to new led headlight bulb pigtail
Posted by a reviewer on Amazon
Isolating hot segment of harness only required a few ties to position
Posted by a reviewer on Amazon
On one of our vehicles i had an issue with the head lights