Pros & Cons
Pros
It is a few millimeters longer than original so you will need to adjust bed. Prints come out really good again and i see no issue with the 9 fin vs the original 4 fins. Also has a silicon cover/insulation over the heater block for more efficient heati... Read More
Highlights
Quality
Prints come out really good again and i see no issue with the 9 fin vs the original 4 fins.
Competitiveness
My hotend failed and needed a replacement.
Overview
- How are reviewers describing this item?
hot, same, great, good and little. - Our engine has profiled the reviewer patterns and has determined that there is high deception involved.
- Our engine has analyzed and discovered that 54.2% of the reviews are reliable.
- This product had a total of 97 reviews as of our last analysis date on Apr 1 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
All settings the same with no change to print
Posted by a reviewer on Amazon
The wires are long enough to go to power supply but the extruder terminates to the plug at the power supply and you really cannot reconnect there without also replacing the connector
Posted by a reviewer on Amazon
Had a print come up off the bed and a while later i found the blob had completely covered everything
Posted by a reviewer on Amazon
I think all the heaters are just a little bit different