Posted by a reviewer on Amazon

The print absorbed some of the resin and became rock hard when cured with a uv light

Posted by a reviewer on Amazon

The black is a dark black

Posted by a reviewer on Amazon

The first 1015 layers would print ok but then the print would lift and the nozzle would drag the print around

Posted by a reviewer on Amazon

I tried different nozzle and bed temps changing the speed layer height glue stick no glue stick glass build surface leveled and releveled the bed over and over with the same issue

Posted by a reviewer on Amazon

Prints at about the same settings as regular pla but had to go up by 5 degrees on the nozzle temp

Posted by a reviewer on Amazon

I went through a lot of failure prints mostly due to the first layer not adhering to the bed

Posted by a reviewer on Amazon

I even tried hairspray that just made a giant mess

Posted by a reviewer on Amazon

Eventually i figured out that for my kingroon i had to have a super hot bed temp for my first layer then turn it down to about 50 for the rest of the print