Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
The only downside is that that spool itself it pretty spartan for any information except the very basics like the color, diameter, type and printing temp. I typically run at the low temp side, just to keep any possible heat creep down that will eventu... Read More
Worked great, detail is amazing. This stuff is the bomb. Highly recommend. Used to make a large (each edge is 4 inches) translucent d20.
Cons
It officially is the worst filament i’ve purchased and i will not purchase again. I'm not even sure it's the same filament as advertised. Do not buy it, go with american made.
Highlights
Quality
I like the quality and it doesn't tangle.
That being said, the quality of the actual filament is great, and i likely just got a bad roll.
I tried printing with it and was shocked by the quality.
Packaging/appearance
Also, get a good bed-level and if using glass, the 220c print doesn't really require as much glue depending on brim, area the m... Read More
Competitiveness
I will use sunlu for all future prints.
After some experimentation, i found that my prints work best at 220c.
Overview
- How are reviewers describing this item?
fine, color, same, great and different. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 14,514 reviews as of our last analysis date on May 26 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Color is thin but prints fine at 210 degree nozzle 69 degree bed on prusa mk3
Posted by a reviewer on Amazon
The media could not be loaded
Posted by a reviewer on Amazon
Kinda stringy on print once finished
Posted by a reviewer on Amazon
Was tangled on spool when i received it
Posted by a reviewer on Amazon
For ender 3 and similar if you are used to slapping in some hatchbox pla and running 200c and having no or relatively few issues you cannot just change to this pla
Posted by a reviewer on Amazon
At 200c it is probably going to clog
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found