What does this mean?
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Loosen the old belt, remove old tensioner, bolt on new tensioner with included t nuts, attach belt and tighten. The only modification i had to do is the chiron uses one of the bolts from the old pulley wheel mount as it’s x-axis homing stop.
This tensioner is a must for all creality 3d printers. While i like printing mods in general, this is just more solid, easy to adjust and fits the rail and belt perfectly. Metal lasts longer and it gives a more finished appearance.
Cons
New variants are machined with a much looser tolerance. The biggest problem i have with this tensioner is the poor quality idler. The pulley is too small and the belt will run against the 2020 extrusion.
Highlights
Quality
So far i am happy with the quality of this item.
Simple to install and works great to keep the right amount of tension on my ender 3.
Replaced a printed (pla) tensioner on my cr-10 mini that came apart after a year or two of wear and tear.
Within minutes, i had this installed to my ender 3 pro, and belt slack was gone seconds later.
Price
This is very good for the price, highly recommend this product
Great bargain, looking forward to enhancing the y-axis later, too!
Because this simple add-on cost less than the amount of filament i've wasted trying to figure out what's going wrong, and could... Read More
The price is low enough i am not sure why anyone wouldn't pick this up.
Shipping
Thanks unitak3d for a great product and super fast amazon shipping!
Competitiveness
This was a cheaper option than purchasing a oem part and a much better alternative.
Overview
- How are reviewers describing this item?
easy, quality, great, right and pro. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 401 reviews as of our last analysis date on Jul 15 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Not sure what happened but there was a pop cracking noise and a piece went flying while using my ender 3 v3
Posted by a reviewer on Amazon
After some investigation it appeared the adjuster failed cracking easily since just plastic
Posted by a reviewer on Amazon
The replacement part is some sort of metal good price and easily installed
Posted by a reviewer on Amazon
The price is low enough i am not sure why anyone wouldnt pick this up
Posted by a reviewer on Amazon
Not really sure if i can find a better one
Posted by a reviewer on Amazon
The only problem is that they get loose over long periods of time like i have to tighten once a month of continuous use
Posted by a reviewer on Amazon
For my ender 3 i did not have to re use any of the standard hardware which many people said they had to
Posted by a reviewer on Amazon
I did not and i did not have to take the belt off to install this
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
