What does this mean?Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Highlights
Quality
It's a bit tricky to get them to work, but i'm happy with the results.
I am very pleased with this sensor and i would recommend it 100%.
This worked great with the very thin stock ender build plate but performed terribly with a glass bed.
On my cr10s pro the old capacitance censer that came with the printer was and always will be crap.
Packaging/appearance
But lots of upgrades since then)it works great right out of the packaging, just needed to flash marlin to the board and change ... Read More
Competitiveness
Made my creality cr-10s pro work more reliably and consistently.
On my tronxy x5s, i needed 16 points to get it to work.
My creality cr-10s pro sensor died after my first print.
Overview
- How are reviewers describing this item?
great, pro, same and better. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 205 reviews as of our last analysis date on Mar 24 2021.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Works great way better then factory installed sensor on cr10s pro creality should really switch to this with original sensor i could not start a print with out being present in the room for a live level as it was printing the skirt rendering my astropi useless for remote control now i havent adjust z off set since installed
Posted by a reviewer on Amazon
If you think you got it then auto home keep a finger on the off switch in case you did not set it correct there are videos on how to connect it up but they fail to tell you too do a manual setup first time
Posted by a reviewer on Amazon
Requires slight adjusting every time its used does not hold an exact zero
Posted by a reviewer on Amazon
The caps are just held in with superglue you can use a knife edge between the metal case and the lid to pry it off
Posted by a reviewer on Amazon
In my case it did work just fine at 5v
Posted by a reviewer on Amazon
There is no screw to adjust sensitivity but obviously raising and lowering the sensor will achieve the same thing
Posted by a reviewer on Amazon
I mistakingly bought this thinking it would sense fine with an uncovered glass bed on my 3d printer but found that it will only sense the aluminum below
Posted by a reviewer on Amazon
Considering my glass and aluminum are actually very flat this has not been an issue to my application but beware not to make the same mistake as i did
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Add Fakespot to your browser, Secure Shopping on the go.
Download Fakespot for Browsers
