Highlights
Quality
The product works very well with my drill press.
I was very pleased with the performance of the tool.
Used to wood with the pre-cut hole to hold this hole saw in place while i cut into our ceramic tile (would have been tough to d... Read More
So, i finished the cuts with a uxcell and joiner 25 mm diamond hole saw cutters, with the uxcell doing most of the cutting.
Price
I thought this will wear both bits given the price.
Shipping
Great hole saw for day to day job use price and shipping was great.
Packaging/appearance
But, the plumbing had been installed deeper than the tile, and so i needed to cut some of the porcelain tile above the shower c... Read More
Reading the other reviews, i used a piece of wood and cut out a hole in the wood to use as a template.
Competitiveness
Much nicer hole saws than expected for the price.
Probably i would have used a bimetal hole saw cutter to go through the cement board backing had i needed to go deeper.
Overview
- How are reviewers describing this item?
cut, great, through, needed and good. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 88 reviews as of our last analysis date on Dec 8 2020.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I bought 3 just in case they didnt last thru the project
Posted by a reviewer on Amazon
You have to regularly irrigate the cut and the cutters with water otherwise the cutting stops because of the accumulated dust clogging up the fine diamonds
Posted by a reviewer on Amazon
I wore safety glasses and an n95 dust mask and also wrapped the wren in a towel and kept my hands under the towel mostly to protect the wren and my hands from all the dust but also in case any of the cutters broke off
Posted by a reviewer on Amazon
The uxcell worked fine you have to start cutting at an angle to get the circular hole going
Posted by a reviewer on Amazon
Although the joiner wheel did not do much cutting i posted it just to show the difference in the axles the joiner has two thicknesses of shafts im not sure if that makes it stronger or weaker since the thicker segment could make it stronger but the transition point could be a weak point where the shaft breaks
Posted by a reviewer on Amazon
I had to clean it up with a carbide dremel attachment
Posted by a reviewer on Amazon
I received 2 of these hole saws together
Posted by a reviewer on Amazon
Out performed the 50 bit from lowe’s