Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
The treadmill has been used ~20 years, over 3k miles. Worked perfectly and was a direct replacement for my outer bearings on my axial wraith axle knuckles. Just remember to re-install the thin * washers to the outside bearing hubs.
Great bearings. Spin perfectly and noiselessly - - no trace of rumble or vibration.
Cons
upon receipt, both shields of each bearing totally distorted from *brutally* hammering as manufactured, completely negating the effectiveness of having seals at all.
Highlights
Quality
Needed some shielded ball bearings for a low speed, dirty application for a material handling stand and this worked perfectly.
I used these for a 3d printing spool roller and the bearings are great.
All of the bearing are in bad condition on the walker with rust.
The blade tracks straight and the bearings don't make noise.
Price
Nice, very nice price and item also
Half the price and exactly the same part as from the factory
Sometimes you just need an inexpensive bearing for a non-critical application.
Packaging/appearance
It's uses 6200 bearings to guide the blade, and the originals were so packed full of chips and old grease that no amount of cle... Read More
Overview
- How are reviewers describing this item?
fit, great, size, old and motor. - Our engine has profiled the reviewer patterns and has determined that there may be deception involved.
- Our engine has determined that the review content quality is low.
- Our engine has analyzed and discovered that 61.5% of the reviews are reliable.
- This product had a total of 500 reviews as of our last analysis date on May 19 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
The treadmill has been used 20 years over 3k miles
Posted by a reviewer on Amazon
A loud noise happens recently
Posted by a reviewer on Amazon
The treadmill motor has two different sizes bearing
Posted by a reviewer on Amazon
This one is still good but just replace both at the same time
Posted by a reviewer on Amazon
Is not tight fit with the bore
Posted by a reviewer on Amazon
I installed these bearings on the rear wheels of a drive rollator
Posted by a reviewer on Amazon
I only needed to do one rear wheel but i decided to to both because of the improvement over the factory bearings
Posted by a reviewer on Amazon
One wrench and 5 minutes does it from start to finish
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found